Dutchwest Federal Airtight Manual

We have the 'top' off the Model 224ACL (Federal Airtight) and have found that the sealant is breaking up all around the metal plating. The stove has a catalytic converter, and that was what we were originally looking at. Then noticed the gasket had come off the damper (by-pass gate) causing it not to seal. That's when we removed the top plate of the stove to get to the damper. Question: What do we use to seal around the metal plates and to seal the 'top' back after we replace the gasket on the damper? I just completely rebuilt a Dutchwest stove. I have the complete written disassembly/assembly instuctions if you need them.

I used 3 tubes of RED DEVIL stove cement for reassembly. Download kurdish fonts zanest. I got the new gasket material from a local stove shop. It was not difficult, a little dirty, and the results were good.

Stunning chic install wood stove in fireplace or majestic dutchwest catalytic with parts photos dutchwest wood stove majestic small consolidated dutchwest wood stove insert a sweetie cast iron burning model dutchwest federal airtight manuals owners manual ferguson s fireplace stove Stove Dutchwest WoodVermont Castings Dutchwest 2460 Homeowner S.

The stove was 15 years old and most of the gaskets were dried out and some of the cement seals were deteriorated. Most important thing is to clean out ALL the old cement from the joints and make the joints perfectly clean down to bare metal. I used a wire brush wheel on a drill and a hand wire brush and some small scraper tools. I just completely rebuilt a Dutchwest stove. I have the complete written disassembly/assembly instuctions if you need them. I used 3 tubes of RED DEVIL stove cement for reassembly. I got the new gasket material from a local stove shop. Umk3 juggernaut hack rom tools.

It was not difficult, a little dirty, and the results were good. The stove was 15 years old and most of the gaskets were dried out and some of the cement seals were deteriorated. Most important thing is to clean out ALL the old cement from the joints and make the joints perfectly clean down to bare metal. I used a wire brush wheel on a drill and a hand wire brush and some small scraper tools.Any chance you still have the Dutchwest rebuild instructions, I am about to rebuild mine and would like some additional guidance.

Frankly, I wouldn't buy a cast iron stove --- especially not a modern cast iron catalytic stove. Cast iron was the material of choice for building stoves ---- a hundred years ago. It was the best way to build a metal stove, but various pieces had to be bolted together --- not an especially durable method of assembly. These days sheet steel stoves that are welded together are the material of choice. They are far stronger, resistant to cracking due to temperature changes and are welded into one main piece in most cases. They are far more difficult to ovwerheat and damage than cast iron stoves. The woes of cast iron stove owners are detailed at.